Method Statement for Dewatering System [Template] 1. IntroductionThis Method Statement for Dewatering System defines the sequence and the control procedures to be followed for the dewatering of xxxxx project. What is dewatering? Dewatering is described as the control of surface and subsurface hydrologic environments so as to permit the construction
This method statement defines the methodology for execution of backfilling and compaction procedure related to earthwork & to describe the sequence of activities, utilization of resources, documents & drawings involved, maintaining & recording documents & data to meet project specific & contractual obligations and risk assessment for the activities involved.
What is the pile head trimming /cut off method statement? Pile head trimming or cut off method statement is the documentation requirement related to piling works methodology submitted to the project consultant for approval prior to proceeding with its implementation. Failure to secure this approved document is one of the
What is the method statement for excavation (Open-cut excavation up to formation level)? This method statement for excavation defines the sequence and control procedures to be followed for excavation works (Open-cut excavation up to formation level) in the construction projects. This process also provides practical guidance to manage health and
This Method Statement for Tower Crane Installation can be converted into template which can be use as part of the submission for QA documentation particularly of tower crane utilization in construction project. This Method Statement for Tower Crane Installation defines the sequence and describes the control procedures to be followed
Table of Contents 1. Purpose 2. Scope 3. System Description4. Definitions 5. References 6. Abbreviations 7. Responsibilities 8. Resources 9. Procedure 10. Health Safety and Environment11. Quality Assurance and Quality Control 12. Attachments1. PURPOSE This Method Statement formalizes the requirements for the Installation of Cable Trays, Ladders, and Trunking System.
What is Crosshole Sonic Logging? Crosshole Sonic Logging (CSL) is carried out on drilled shafts/bored piles to inspect the structural integrity, and extent and location of defects, if any, by sending ultrasonic pulses through the concrete from one probe to another (probes located in parallel tubes). The CSL is carried out
What is a micropile? A micropile is a small-diameter (commonly less than 300 mm), drilled and grouted replacement pile that is typically reinforced which can either withstand axial or lateral loads or both of these. What we mean here by the term “replacement” pile is the installation by removal and
What is Method Statement for the Repair of Concrete? This method statement for the repair of concrete describes the details of rectification for most common construction defects of concrete structures right after the casting activity and formworks deshuttering such as concrete cracking (non-structural and structural cracks), honeycombs or spalling, pinholes