This ups commissioning document presents a comprehensive guide for testing and commissioning of Uninterruptible Power Supply system (UPS). It is highly recommended that an independent third-party commissioning agent (CA), not associated with either the equipment vendor or the installer, perform the commissioning. During testing procedures, the equipment vendor’s service technicianContinue Reading
Description This procedure describes the Testing and Commissioning of Building Management System (BMS) in accordance with the standards and requirements of project specifications. Introduction This covers the MEP activities related to the Testing & Commissioning of Building Management System (BMS). Definitions T & C – Testing and CommissioningINR – InspectionContinue Reading
Objective The Testing and Commissioning of Drainage Piping (Above ground) describe in detail the method of supply and installation including testing works for soil, waste & vent piping with related accessories which are executed in a safe manner and in accordance with the project requirements. This procedure ensures that allContinue Reading
Purpose The purpose of testing and commissioning of CCTV system is to guarantee that the installed system’s performance satisfies the specified design intent through a series of tests and adjustments, as well as to confirm the equipment and system’s appropriate operation following installation. This procedure shall ensure that the testingContinue Reading
Purpose This defines the method for Testing and Commissioning of Uninterrupted Power Supply (UPS)-Single Phase by ensuring that the execution complies with the requirements and intended satisfactory level. This procedure aims that quality assurance and quality control activities are adopted by the contractor in a systematic manner in accordance withContinue Reading
Purpose This defines the method for testing and commissioning of fire suppression systems installed within the project. The work referred to in this section consists of providing all labor, necessary tools, and services required for the testing, and commissioning of all fire suppression systems installed in the buildings. All finalContinue Reading
Purpose This describes in detail the Testing & Commissioning of Submersible Pump Sets with related accessories are executed in a safe manner and in accordance with the project requirements. Scope The work method was prepared for the complete execution of the Testing & Commissioning of Submersible Pump Sets with accessories.Continue Reading
Testing and commissioning of the diesel generator set in compliance with the specified tolerance and limitations outlined with industrial standards, guidelines with reference to the project specification, manufacturer’s instructions, and authority requirements. The entire Testing and Commissioning of Diesel Generator Set shall be performed by the supplier’s specialist/third party-experienced engineer.Continue Reading
This testing and commissioning of fire alarm system covers the on-site installation as defined in the project specifications and approved shop drawings. Scope of work The scope of work involves the programming, testing, and commissioning of the fire detection systems. References Project specificationsApproved fire alarm shop drawingsManufacturer recommendations/ installations instructionProjectContinue Reading